#HD PVR 2 NO SIGNAL ON TV TV#

Try temporarily swapping the PVR for the other box. See the following thread on IR interference.ĥ. Have you added some new lights recently - perhaps they are interfering with the IR signal. It's unlikely this is the problem since you tried the component video cables and had the same problem, but it's good to turn this off anyway.Ĥ. Turn off the 'HDMI link' feature in the TV.

#HD PVR 2 NO SIGNAL ON TV TV#

Also, try the Samsung remote on the TV by itself.ģ. The light should flash once for TV, once for PVR and not any more. Check to make sure the remote 'power' button isn't 'stuck' and sending the signal to the TV for a long time - you can confirm this by looking at the lights on the remote. Reprogramme the remote so that it turns the TV on first instead of the PVR.Ģ. Sorry, this guide is only available to view on a desktop computer. I purchased my Rogers PVR to avoid the monthly rental fee, and now this happens.ġ. No Signal Interactive Guide HDPVRCapture Home No Signal Interactive Guide If you are having signal detection issues when using your HDPVR capturing device with the HDPVRCapture application, try using our signal detection interactive guide to help troubleshoot the issue. I have another Rogers HD box (non-PVR) in my basement with an LG TV and the problem does not occur. I have also tried switch from HDMI connection to the RBG cables, but the same problem occurs. Obviously this is bad for the TV and I'm almost 100% it has something to do with the PVR. It's as if the TV is waiting for the PVR to provide the signal, but there's a delay which causes the TV to repeatedly turn on and off. But what happens is that the Rogers PVR sort of goes into this standby mode when it's not in use, and then when I try to turn the TV on, the same problem occurs (repeated on/off clicks from the TV). I've tried to fix this problem by always keeping the PVR on and only turning the TV on/off when needed. Now what happens is that when I click the power button on the remove, the PVR turns on, but the TV turns on and off repeatedly about 4-8 times before actually staying on. For two years, it has worked completely fine. Xbox360 hdmi signal: When I connect my xbox360 to Hauppauge hd pvr 2 with HDMI-cable to record a game video Hauppauge-box doesnt see my video source at all. I have programmed my Rogers remote so that when I click the power button, it first turns on my PVR and then my TV.

I've been having this problem with my Samsung TV and/or Rogers PVR.

Hd pvr 2 no signal on tv